NANO V3.0 Development Board – UNSOLDERED & USB Cable For Beginners

Product Description

The nano is a small complete and breadboard-friendly board based on the atmega rudr nano x it has more or less the same functionality as the duemilanove but in a different package it lacks only a dc power jack and works with a mini-b usb cable instead of a standard one getting started you can find in the getting started section all the information you need to configure your board use the rudr software ide and start tinker with coding and electronics Flash Memory: 32KB ( ATmega328 ) (of which 2 KB used by bootloader) SRAM: 2KB (ATmega328) EEPROM: 1KB (ATmega328) Clock Speed: 16MHz Kit Contains: Soldered Nano compatible, Nano Cable Mini USB to USB ( cable colour might change from the one shown in picture) Note: Need to install CH341SER driver Digital I/O Pins: 14 (of which 6 provide PWM output) Analog Input Pins: 8 DC Current per I/O Pin: 40mA Microcontroller Atmel ATmega328 Operating Voltage (logic level): 5V Input Voltage (recommended): 7V ~ 12V Input Voltage (limits): 6V ~ 20 V ..Flash Memory: 32KB ( ATmega328 ) (of which 2 KB used by bootloader) SRAM: 2KB (ATmega328) EEPROM: 1KB (ATmega328) Clock Speed: 16MHz
Kit Contains: Soldered Nano compatible, Nano Cable Mini USB to USB ( cable color might change from the one shown in picture)
Note: Need to install CH341SER driver
Digital I/O Pins: 14 (of which 6 provide PWM output) Analog Input Pins: 8 DC Current per I/O Pin: 40mA
Microcontroller Atmel ATmega328 Operating Voltage (logic level): 5V Input Voltage (recommended): 7V ~ 12V Input Voltage (limits): 6V ~ 20 V